C1105 Daewoo Auto Trouble Code

Parts or components should not be replaced with reference to only a C1105 Daewoo DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

The problem is caused by the variable cylinder management system switching on and off during light throttle conditions, at cruising speeds, or when driving on flat roads. The constant switching causes excessive oil consumption and the trouble codes appear when oil pressure drops to the point where it can no longer operate the VCM system.

C1105 Daewoo Possible Solution:

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

Daewoo C1105 Engine Trouble Code Description For All Models :

C1105 meaning and repair processes are the same for all Daewoo models.

After understanding C1105 Daewoo error code for your Daewoo car, now you can repair yourself.
C1105 Daewoo Trouble Repair Process:

If your vehicle failed a C1105 Daewoo test and the C1105 Daewoo Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression. Use your OBD Express DIY to look at the oxygen sensor outputs, coolant temperature, airflow, calculated engine load, and inlet air temperature.

c1105 is a very common fault code for the thermostat. If you have this fault it will need to be replaced. I would start with that repair, clear the faults and perform a 30 minute battery reset(disconnect the negative cable off of the battery) and retest the vehicle.

Code Search

Please fill the search bar to find Auto Trouble Code meaning.

Example: 0120

Share This C1105 Daewoo Page:
FB TW G+